AeroCut XPro OPERATION MANUAL
40
5.4
Skew adjustment
・
If print is skew on the sheet, the angle of the side guide can be adjusted.
①
The angle of the side guide changes as
the skew adjustment dial is turned.
②
Set the sheets again.
5.5
Creaser adjustment
・
Turn the lever shown in the drawing below to adjust the crease depth.
・
If creasing pressure is not enough even the lever is adjusted, pressing CREASE 1
button and changing creasing mode to CREASE 2 may help.
CREASE 2 mode enables the machine to cycle the creaser twice at creasing positions,
which results in deeper creases.
Note.
Use less than 3 in case of creasing on heavier paper than 300 gsm to avoid paper jam.
Lever
Deep
Shallow
Skew
adjustment dial
Side guide