AeroCut XPro OPERATION MANUAL
44
5.6.2
If the cut measurement does not match the input value
・
If the actual size and measurements of output differs from input values, calibrate the
machine via calibration screen.
①
In cases the width of a card or a top margin is different from
inputted values, Input differences between inputted values
and actual sizes of outputs into A, B, C and D.
・
If you press OK after you input values into A, B, C and D,
those values will be added to each total measurements
which are circled on the image below.
・
Then, A, B, C and D will be reset to 0.000”.
・
You can change the measurement by 0.002”.
・
Each adjustment should be within
±
0.080” at one time.
・
If the gap is more than
±
0.080”, repeat the process until
the desired measurement is reached.
EX:
If the input value is 0.200” and cut
measurement is 0.175”, input +0.025.
If the input value is 3.500” and the cut
measurement is 3.560”, input -0.060.
Reset the machine to the factory setting, all the adjusted values
will be 0.
Save the adjusted values and go back to Manual speed Screen
Go back to manual speed Screen without making any changes.
○
A
○
B
○
C
○
D
