功能说明:
此功能是当接收机收不到信号时,可以采用预先设定的参数,进行保护.
点触
失控保护功能
显示当前
10
个通道的预设状态；通道状态显示为
关闭
时当接收机丢失信号，相关联的舵机将保持最后收到的位置信号；
开启时舵机将返回预先设定位置。所有通道设置可以设置当前已开启的
所有通道的位置。
如图
21
.
53
所示，当接收机丢失信号，
CH2
升降
设置到
-50%
位置，
其它将保持它们最后收到信号时的位置。
设置方法：
点触一个通道设置
失控保护功能
并激活(点击 图标,如图)，将对应该通道
开关、旋钮、逻辑开关
或
摇杆
通道拨到需要的
位置，然后保持该位置并点触返回按钮，舵机的位置将保存；
当激活了多个通道
失控保护功能
时，可点触
所有通道
设置，将对应的通道
开关、旋钮、逻辑开关
或
摇杆
通道拨到需要的位
置，按系统提示点触
确认
按钮，舵机的位置将保存；
如图
21
.
54
所示，
CH2
升降及
CH4
方向通道的
失控保护功能
被激活，并均设置到
-100%
位置。
(
Pic 21.52)
Setup:
Touch a channel to set its
failsafe
behavior. If activated, set the channel to the desired position using the corresponding channel
switch, knob, logic switch or stick
then while maintaining that position, touch the back button. The position of the servo is then
memorized.
If multiple channel
failsafe
are activated, set the
channels
to the desired position using the corresponding channel
switch, knob,
logic switch or stick
then while maintaining that position, touch the
back
button. The position of the servo is then memorized.
The
failsafe
on the channel 2 (elevator) and channel 4(rudder) are activated and set to -100%.
(
Pic
21.54)
Function Details :
This function is used to protect aircraft with parameters set in advance when
the receivers don
'
t receive the signals.
Press
failsafe function
and it will display the current setting of 10 channels.
Off
means that in case of a loss of signal, the corresponding servo will keep
its last received position.. The servo will move the position you preset . All
the channel is able to be set failsafe.
As shown in picture 21.50: Only
CH2 Ele
is set to -50% in case of a loss
of signal. The others will keep their previous position.
失控保护功能
failsafe function
:
39
Digital proportional radio control system
(
Pic 21.53)
