TSI Instruments DustTrak 8535, Руководство по эксплуатации и обслуживанию

Страница: 33 / 70

Setting Up 23
Supplying Power to the DustTrak
™
II/DRX Aerosol
Monitor (and optional accessories)
The DustTrak
™ II/DRX Aerosol Monitor may be powered in one of
three ways when used with the Model 8535 Environmental Enclosure:
1. Use external weatherproof
AC adapter, when AC power
is desired.
2. Use the optional Battery
Pack(s) (Single or Dual).
3. Use the optional Solar Cell
Power System.
4. The internal DC power split
cable is used to connect
power from any of the
above-mentioned sources to
the DustTra
k™ monitor.
Simply connect the 3-pin
connector end of the cable
to either the Battery Pack
output or to the Enclosure
DC connector. The other
end of the cable has two DC
power plugs
—one which
only fits the DustTra
k™
power jack, and another that
is no longer used. Figure 24: Internal DC
Power Connections
Using the External Weatherproof AC Adapter
Make sure that the external weatherproof AC adapter is securely
mounted to the outside of the Enclosure and that its DC output cable
is connected to the DC input connector on the outside of the
Enclosure (as described earlier in this manual). After the adapter is
plugged into an AC voltage source, DC voltage is then available on
the inside of the case at the 3-pin connector interface, and the
internal DC power split cable is used to route that power to the
DustTrak
™ monitor.
NOTE
Universal input AC plug adapters are included with the 8535
Environmental Enclosure for changing to a different AC plug style.