TSI Instruments DustTrak 8535, Руководство по эксплуатации и обслуживанию

Страница: 19 / 70

9
Chapter 2
Setting Up
The setup of the Environmental Enclosure is an important part in
allowing reliable and accurate sampling of aerosols in a wide range of
conditions. TSI
®
cannot ensure accurate measurements if any of the
components are set up incorrectly. Failure to follow these procedures
could result in damage to the enclosure or its components.
Install the Aerosol or Respirable Aerosol Inlet
The inlet assembly allows ambient aerosols to be sampled efficiently
in a wide range of conditions. Proper installation into its sampling
position ensures that the DustTrak
™ II/DRX aerosol monitor
measures an accurate ambient aerosol mass concentration. Follow
these instructions to install either of the aerosol inlets:
1. Remove the Inlet Transport Plug from bubble pack.
C A U T I O N
Always hold the inlet assembly by the knurled portion
of the tube.
DO NOT twist on the inlet assembly cap.
2. Thread the inlet assembly into upper inlet ring found on the top of
the Environmental Enclosure (see Figure 3).
Figure 3: Thread the Inlet into the Inlet Ring