Setting Up
27
Setting-up the Solar Cell Power System
(optional accessory)
The full Solar Cell Power System is shown in Figure 26. The following
section details the setup of this system.
I M P O R T A N T
Make all Solar Cell Power System electrical connections in the
order outlined below. Damage to the system can occur if
connections are not made in this order.
Figure 26: Solar Cell Power System
1. Remove the Solar Battery from its packaging and place it in the
Solar Battery Enclosure box. Make sure that the battery positive
(+) terminal is on the right (the positive terminal is noted on the
battery with a RED marking). Remove the battery terminals using
an adjustable wrench and connect the ring terminal ended wires
from the solar charge controller to the battery terminals (see
Figure 27).
NOTE
There are two wires coming from the charge controller: one
is
BLACK
and is labeled
(+);
the other is
WHITE
and is
labeled
(
–).
The
BLACK
(+)
wire should be connected to the battery
positive
(+)
terminal, which has a red marking on the top of
the battery.
The
WHITE
(
–)
wire should be connected to the battery
negative
(
–)
terminal.
Содержание DustTrak 8535
