TS Industrie SAELEN GS/LYNX14P, Руководство по эксплуатации

Страница: 31 / 44

GS/ LYNX 14P
2014-12-09
31
Maintenance
After sharpening, the length A must not fall below 50 mm (a new knife has a length of 60 mm).
Do only use screws of type TCHC 12 X 40 class 12.9.
-
Tighten screws of class 12.9 applying a torque of 157 Nm and ensure correct seat
of knives and inserts.
-
Close expulsion channel and hoods again.
-
Start the engine and have it run until is has reached operating temperature.
-
Accelerate the engine up to maximum speed and check if the machine produces unusual vibrations.
Tightening with the correct torque is important to prevent the screws from
coming loose.
VENT OPENING UNDER THE ROTOR
For improving the rotor ventilation and the material expulsions, the LYNX is fitted with another vent open-
ing under the rotor, additionally to the standard two lateral vent openings.
These air intakes must be checked for cleanliness and free passage in regular intervals.