Rev: B
Vizion Install Appendix E C180, C182-
C182D, C185
TruTrak Doc: 255
5
2.2.
Wiring Harness / Controller Mounting Instructions
1.
Begin by disconnecting the aircraft battery.
2.
Select a mounting location for the autopilot controller.
2.1.
Consider the overall mounting depth of the controller with pitot, static, and
electrical connections and allow clearance where necessary, especially
surrounding the moving yoke assembly.
2.2.
Ensure that mounting location does not require autopilot servo lines to run
near com antenna coax.
2.3.
Ensure that there is sufficient space near the autopilot controller to install the
Vizion Limitations Placard (Trutrak P/N 8300-092)
3.
Remove the instrument panel and panel overlays as necessary.
4.
Remove the seats.
5.
Remove the left A-pillar and kick panel trim.
6.
Remove carpeting.
7.
Wiring harness routing.
7.1.
Route the pitch (white) and roll (black) servo harnesses from the controller
to the left side of the panel.
7.2.
Route the roll (black) servo harness up the left A pillar and out the leading
edge of the left wing as shown in Figure 2-1, Figure 2-2, and Figure 2-3.
Extend the excess harness out the inspection hole just forward of the
