Rev: B
Vizion Install Appendix E C180, C182-
C182D, C185
TruTrak Doc: 255
24
Figure 3-16
17.
Apply blue threadlocker (Loctite242 or equivalent) to the threaded shank of
both rod ends. Rotate the pushrod until the rod end bearings on each end are
threaded in equally and the link sensor connector is pointed directly down
then tighten the jam nuts to 20-25 in-lb.
18.
Move the yoke throughout the full range of travel and check for binding in the
rod end bearings. If binding exists adjust the rod end bearings and jam nuts
to eliminate it.
19.
Ensure that aircraft stops are contacted prior to servo stops. Adjust
length of pushrod as needed until servo stops are not contacted when
controls are moved to both ends of travel.
20.
Complete routing of the pitch servo wiring harness and trim to length.
21.
Terminate the pitch servo wiring harness per the Vizion wiring diagram
USING OPTION B
in the Vizion PMA Installation Guide (TruTrak Doc. 166)
using a Right Angle D-sub 9 Pin Backshell Kit (P/N 8210-011).
22.
The pitch servo connector backshell and slidelock should be assembled as
shown in Figure 3-17.
