Rev: B
Vizion Install Appendix E C180, C182-
C182D, C185
TruTrak Doc: 255
30
For Vizion software version PV.40 follow the steps below:
1)
PRESS and HOLD
KNOB
2)
Apply power to autopilot and GPS
3)
RELEASE
KNOB.
4)
PRESS
ALT button to advance to MIN BACKLIGHT
5)
PRESS
ALT button to advance to SETUP ENABLE.
6)
ROTATE
ALT button to select a value of
10
.
7)
PRESS
KNOB to exit.
8)
PRESS and HOLD
MODE button until LAT ACTIVITY is shown.
9)
ROTATE
KNOB to select a LAT ACTIVITY of
17
10)
PRESS
ALT button to advance to next setup screen.
11)
ROTATE
KNOB to select a BAUD that matches the baud rate of the GPS (this will
be either
4800
or
9600
, refer to Approved GPS List (Doc 186) for information
about approved GPS units).
12)
PRESS
ALT button to advance to next setup screen.
13)
ROTATE
KNOB to select a BANK ANGLE of
MED
.
14)
PRESS
ALT button to advance to next setup screen.
15)
ROTATE
KNOB to select a MICROACTIVITY of
10
.
16)
PRESS
ALT button to advance to next setup screen.
17)
ROTATE
KNOB to select a GPSS GAIN of
16
.
18)
PRESS
ALT button to advance to next setup screen.
19)
ROTATE
KNOB to set ROLL REV to
Y
.
20)
PRESS
KNOB to exit lateral setup and return to the home screen.
21)
PRESS
and HOLD
ALT button until VRT ACTIVITY is shown.
22)
WHILE CONTINUING TO HOLD
ALT,
PRESS
MODE.
23)
RELEASE
MODE and ALT.
24)
PRESS
MODE until MAC is displayed.
25)
ROTATE
KNOB to set MAC to
2
.
26)
Repeatedly PRESS ALT button until EFIS TYPE is displayed
27)
R
OTATE
KNOB to set EFIS TYPE to:
1
– if the autopilot is connected to an ASPEN,
2
– if the autopilot is connected to a G5,
0
– if the autopilot is connected to any other GPS
28)
PRESS
KNOB to exit menu and return to home screen.
29)
Do not remove power from autopilot.
4.2.
Vertical Autopilot Settings
For Vizion software version PV.30 follow the steps below:
1)
PRESS and HOLD
ALT button until VRT ACTIVITY is shown.
2)
ROTATE
KNOB to select a VRT ACTIVITY of
16
.
3)
PRESS
ALT button to advance to next setup screen.
