Rev: B
Vizion Install Appendix E C180, C182-
C182D, C185
TruTrak Doc: 255
29
4.
Cessna C180, C182-C182D, C185 Autopilot Settings
Once all wiring is complete, verified, and the GPS setup has been completed (Vizion
PMA Installation Guide (TruTrak Doc. 166)), follow the steps below to verify proper
autopilot settings.
THIS STEP MUST BE COMPLETED PRIOR TO
GROUND CHECK AND FLIGHT CHECK!!!
4.1.
Lateral Autopilot Settings
For Vizion software version PV.30 follow the steps below:
1)
PRESS and HOLD
KNOB
2)
Apply power to autopilot and GPS
3)
RELEASE
KNOB.
4)
PRESS
KNOB to advance to MIN BACKLIGHT
5)
PRESS
KNOB to advance to SETUP ENABLE.
6)
ROTATE
KNOB to select a value of
10
.
7)
PRESS
KNOB to exit.
8)
PRESS and HOLD
MODE button until LAT ACTIVITY is shown.
9)
ROTATE
KNOB to select a LAT ACTIVITY of
17
10)
PRESS
ALT button to advance to next setup screen.
11)
ROTATE
KNOB to select a BAUD that matches the baud rate of the GPS (this will
be either
4800
or
9600
, refer to Approved GPS List (Doc 186) for information
about approved GPS units).
12)
PRESS
ALT button to advance to next setup screen.
13)
ROTATE
KNOB to select a BANK ANGLE of
MED
.
14)
PRESS
ALT button to advance to next setup screen.
15)
ROTATE
KNOB to select a MICROACTIVITY of
10
.
16)
PRESS
ALT button to advance to next setup screen.
17)
ROTATE
KNOB to select a GPSS GAIN of
16
.
18)
PRESS
ALT button to advance to next setup screen.
19)
ROTATE
KNOB to set ROLL REV to
Y
.
20)
PRESS
KNOB exit lateral setup and return to the home screen.
21)
PRESS
and HOLD
ALT button until VRT ACTIVITY is shown.
22)
WHILE CONTINUING TO HOLD
ALT,
PRESS
MODE.
23)
RELEASE
MODE and ALT.
24)
PRESS
MODE until MAC is displayed.
25)
ROTATE
KNOB to set MAC to
2
.
26)
PRESS
KNOB to exit menu and return to home screen.
27)
Do not remove power from autopilot.
