Rev: B
Vizion Install Appendix E C180, C182-
C182D, C185
TruTrak Doc: 255
23
11.
Remove the AN4 bolt securing the elevator push rod to the bottom of the
elevator bellcrank and replace with hardware as shown in Figure 3-15.
Figure 3-15
12.
Partially thread the link sensor end of the Early Model 182 Pitch Push Rod
(7200-112) in the MM-4 rod end attached to the elevator bellcrank.
13.
Fully thread an AN345-10 nut on a MM3-300 rod end then partially thread the
MM3-300 rod end into the forward end of the Early Model 182 Pitch Push Rod
(7200-112)).
14.
Have an assistant hold the yoke in the full aft position and rotate the servo arm
against the aft stop on the pitch servo bracket.
15.
Thread the MM-3-300 rod end bearing into the servo end of the pushrod until
the pushrod is the correct length to align with the drive point on the servo arm.
16.
Attach the pushrod to the pitch servo arm with hardware as shown in Figure
3-16 and torque to 20-25 in-lb.
