TRUST 1210K POWERC@M OPTICAL ZOOM
U K
USB busy (PC mode)
The camera cannot focus
on the subject
Blinking Flash
charge
processing
Flash indicator
(1, fig. 2)
red
ON Flash
ready
Self-timer
(8, fig. 1)
red Blinking
For the first seven seconds,
the LED blinks at 1 second
intervals.
For the final three seconds,
the LED blinks rapidly at
0.5-second intervals.
Whenever the LCD monitor
is off
When the USB cable is
connected
Mode dial
(2, fig. 2)
green ON
When the A/V cable is
connected
Table 5: Camera status led
5
Install / replace batteries
There are 2 ways to provide this camera with power. You can use batteries or
alternatively an AC (100~250V) adapter (DC 3.3V 2.0A). (not supplied!)
To install the batteries:
1.
Turn off the camera.
2.
Open the battery holder on the side of the camera by pressing on the cover
and sliding in the direction of the arrow toward the outside edge of the camera
(1, fig. 7).
3.
Insert batteries into the compartment making sure that the positive
and
negative
ends are properly oriented, as indicated on the compartment’s
interior wall. (2, fig. 7)
4.
Close the battery cover. (3, fig. 7)
The battery condition is shown on the LCD screen (1. fig. 5) as follows:
The batteries are full.
The battery capacity is low. Only a few more photographs can be
taken.
The batteries are empty.
Table 6: Battery conditions
5
