_____________________________________________________________
2-4 Hardware
Installation
transceiver, which has its own power supply), move the jumper block to the
position shown in figure 2-2B.
If you are using AUI with any other printer besides the ones mentioned in
the previous paragraph
, you must use the optional XJ12V voltage converter
,
which provides the 12 volts necessary to power external transceivers. The
XJ12V replaces the jumper block and mounts on the XJet IV-2 as shown in
figure 2-2C.
Important Note:
The XJ12V provides a maximum of 500mA of current, so
make sure that your transceiver does not exceed this limit.
Figure 2-2
Using the XJet IV-2 Jumper Block and XJ12V
Connecting an Internal Print Server to the Printer
XJet 3000 Installation
The XJet 3000 print server is compatible with
EIO-based printers such as
the HP LaserJet 4000, 5000 and 8000.
The XJet 3000 plugs into the I/O slot located on the rear of your printer or
plotter The installation steps are as follows:
1. Turn off the printer or plotter and unplug the power cord.
B
(AUI)
A
(thin)
C
(XJ12V)
JP1 - JP10
JP1 - JP10
JP1 - JP10
