Triumph NTO-10A, Руководство пользователя

Страница: 10 / 20

Page 10 of 20
c. Adjust cables to same tightness. This will allow them to keep the carriages level
as the lift rises.
d. Adjust the carriage cable tension. This is accomplished by tightening the carriage
adjustment nut on top of each carriage. The rear carriage adjustment nut adjust
the opposite post carriage height.
e. The left post carriage nut adjusts the right column carriage, and the right column
carriage nut adjusts the left column carriage. Adjust each cable to approximately
½” side to side play. Check the latch releases to insure the carriage is still
engaged in the appropriate latch.
15. Check cylinders are in place properly. They were installed in factory but may have
moved. Make sure the tip on the bottom of the cylinders fit into the center hole on top of
the cylinder mount in base plate.
16. Pull the pre-attached leaf chain in both sides up and over the chain sheaves on top of
the cylinders if not already done at factory.
17. Mount the power unit on the main side leg to the power unit bracket using the two bolts
and nuts provided.
(Make sure power unit securely attached as it weighs a lot when full of fluid)