Page 17 of 20
k. Do not overload the lift. The rated load capacity is indicated on the lift nameplate.
l.
Only use the vehicle manufacturer’s recommenced lift points
m. After positioning the vehicle on the lift apply the parking brake.
n. Use caution when removing or installing heavy components (center-of-gravity
displacement). And be careful when picking up trucks with heavy equipment in
the bed as this will change the center of gravity of the truck and could lead to
accident. This is very important.
o. Protect all parts of the electrical equipment from humidity and moisture.
i. You must hold the controls in the engaged position to raise or lower the lift.
p. Equalizing System
i. The lift has equalizing cables to ensure level movement of both carriages.
Make sure they are adjusted properly.
q. Collision Prevention Switch
i. A cut off is provided to prevent collision between vehicle roof and cross
member. Test frequently to be sure it is fully operational.
r. Pinch Point Protection
i. During lowering cycles the support arms automatically stop at a height of 4.5
inches from ground.
ii. To lower the lift completely, raise lift off the lock, and hold the dump handle to
lower. Lift travel to the lower limit stops is accompanied by an audible click.
iii. Automatic Arm Restraint = Once the lift is raised, the arm restraints are
locked automatically to avoid any swivel under load. Make sure the locking
gears engage when lifting a load for safety.
5. SAFETY TIPS FOR SERVICING LIFT
a. Maintenance or repair work by trained service personnel only.
b. Turn off the electricity to lift before doing any maintenance or repair work. Any
electrical work on the lift should only be done by certified electricians. This is
especially critical when initially installing the power unit because errors here, if
not done by qualified electricians, will not be covered under warranty.
c. Ensure that ecologically harmful oils are disposed of only in accordance with the
appropriate regulations.
d. Do not use high pressure/steam jet cleaners or caustic cleaning agents on the lift.
Risk of Damage.
e. Do not replace or override the safety devices
e. When you start raise the vehicle a little and then check the disk adapters have
secure contact with vehicle lifting points. Always lift the vehicle using all four
adapters.
f. Close vehicle doors are closed during raising and lowering cycles.
g. Closely watch the vehicle and the lift during raising and lowering cycles. Do not allow
anyone to stay in lift area during raising and lowering cycles.
h. Never allow anyone on lift or inside when raising or lowering the lift.
i. Only use the lift for its intended purpose.
j. Comply with the applicable accident prevention regulations of your area.
b. Lift should only be operated by fully trained personnel.
c. Keep the lift and lift area clean and free of tools, parts, debris, etc.
d. Once the disk adaptors contact the lift points, check arm restraint mechanisms on
each arm for engagement.
Содержание NTO-10A
Страница 3: ...Page 3 of 20...
