Page 15 of 20
5. Turn the disk
adapters so they evenly contact all four lifting points. Add the 1.5”, 3”,
or 6” truck adapter extensions as needed to fully contact the lifting points.
6. Make sure lifting points are free of grease or oil as this might make the adapters slip
off the lifting point when vehicle is raised. VERY IMPORTANT!
7. Do not place any vehicle on the lift at this time. Cycle lift up and down several times
to insure latches click together and all air is removed from the system. To lower the
lift, latch releases must be manually released. Latches will automatically reset once
the lift ascends approximately 20” from base.
8. If latches click out of synchronization, tighten the cable on the one that clicks first.
9. Once the disk adaptors contact the lifting points check arm restraints for
engagement. If necessary, slightly move arms until the gear segments mesh.
10. Never unlatch the arm restraints when the lift is under load.
11. Do not stand under lift when lift is moving and before locks are engaged..
12. Always lift the vehicle using all four adapters.
RAISING VEHICLE
1. During raising and lowering cycle closely watch the vehicle and the lift, do not allow
anyone to stay in lift area and make sure the vehicle doors are closed.
2. Once the disk adapters contact the lift points, check arm restraints for engagement.
After raising the vehicle briefly, stop and check adapters for secure contact.
3. Press button on power unit to begin raising the lift. It may take about 40 to 50
seconds if raising to full height. Remember there are many other stopping points in
between should you not want to raise to full height.
4. Lift stops once button is released or upward travel limit is reached.
5. Observe all accident prevention regulations.
6. Do not allow unauthorized persons to stay under the raised vehicle.
7. Avoid rocking of vehicle. Use stabilizer stands (not provided) to stabilize long
vehicles for extra safety.
8. Fasten the vehicle to the support arms using lashing straps when removing or
installing heavy components. This will keep vehicle for shifting and possibly falling so
very important.
OPERATION
1. Each support arm is provided with an automatic arm restraint which unlatches
automatically when the lift is fully lowered. When the carriages are in the raised
position, the arm restraint can be disengaged by pulling the two release cables.
2. Fully lower the lift and swing the arms to full drive through position.
3. Slowly position vehicle midway between adapters. Apply the parking brake
4. Swing the adjust the telescope arms as required to position adapters under vehicle
manufacturer's recommended lifting points for the vehicle you are working on.
v. Replace or rebuild power units
vi. Check hydraulic cylinder rod and rod ends for deformation or damage.
vii. Check cylinder mount for looseness or damage.
iv. Replace or rebuild air and hydraulic cylinders.
d. The following items should only be performed by trained maintenance expert
i. Replace hydraulic hoses.
ii. Replace chains and rollers.
iii. Replace cables and sheaves.
Содержание NTO-10A
Страница 3: ...Page 3 of 20...
