12
Fig.10
Fig.11
FITTING THE SHOWER TO THE WALL
INSTALLATION - FITTING THE SHOWER TO THE WALL
WARNING!
Check there are no hidden cables or
pipes before drilling holes for wall
plugs. Use great care when using
power tools near water. The use of
a residual current device (RCD) is
recommended when using them.
NOTE:
The control knob is an integral part of the
cover -
DO NOT
attempt to remove it.
• Lift the cover from the backplate.
• Entry positions for the mains water and
electric cable can be found on
Page 3
.
NOTE:
Deviations from the designated entry
points will invalidate product approvals.
• After choosing the site for the shower, use the
backplate to mark the three fixing holes, the
position of which are shown in
(fi g.10)
.
• If bottom entry has been chosen, fit the
appropriate cut-out in the top of the
backplate
(fi g.11)
.
• If top entry has been chosen, fit the
appropriate cut-out in the bottom of the
cover trimplate
(fi g.12)
.
•
Drill and plug the wall.
(An appropriate drill bit
should be used. If the wall is brick, plasterboard
or a soft building block, appropriate wall plugs
and screws should be fitted).