Bezique
iNTrODuCTiON
This book contains all the necessary fitting and
operating instructions for your Triton bezique
electric shower. Please read them carefully.
The shower installation must be carried out by a
suitably qualified person and in the sequence of
this instruction book.
Care taken during the installation will provide a
long, trouble-free life from your shower.
SPECifiCaTiONS
Electrical
nominal power
nominal power
rating at 240V
rating at 230V
9.5kW
−
(40A MCb rating) 8.7kW
−
(40A MCb rating)
10.5kW
−
(45A MCb rating) 9.6kW
−
(45A MCb rating)
Water
Inlet connection – 15mm diameter.
Outlet connection – ½” bSP male thread.
Entry Points
Water – bottom or back.
Cable – top or back.
Materials
backplate, cover, controls, showerhead – AbS.
Sprayplate – Acetal.
Elements – Minerally insulated corrosion resistant
metal sheathing.
Dimensions
Height
−
338mm
Width
−
208mm
Depth
−
95mm
Standards and Approvals
Splashproof rating IPX4.
Complies with the requirements of current british
and European safety standards for household
and similar electrical appliances.
Complies with requirements of the british
Electrotechnical Approvals board (bEAb).
Meets with Compliance with European
Community Directives (CE).
aDViCE TO uSErS
The following points will help you understand
how the shower operates:
a.
The electric heating elements operate at a
constant rate at your chosen power setting. It is the
rate of the water passing through the heater can
which determines the water temperature. (The
slower the flow the hotter the water becomes, and
the faster the flow, the cooler the water).
b.
During winter the mains water supply will be
cooler than in the summer, so the flow rate will
vary between seasons at any one temperature
setting. At different times of the year you may
have to adjust the position of the temperature
control to maintain your desired temperature
setting.
c.
The stabiliser valve minimises variations in
shower temperature during mains water pressure
changes. If changes in shower temperature are
experienced during normal use, it will most
likely be caused by the water pressure falling
near to or below the minimum level. The drop
in pressure may be due to water being drawn
off at other points in the house whilst the
shower is in use. If pressure drops appreciably
below the minimum, the heating elements will
automatically cut out.
If ever the water becomes too hot and you
cannot obtain cooler water, first check
that the sprayplate in the showerhead has
not become blocked.
DO nOT place items such as soap or shampoo
bottles on top of the unit. Liquid could seep
through the joint between the cover and
backplate, and possibly damage the sealing
rubber.
ImpoRtANt:
When first installed the
unit will be empty. It is essential the unit
should contain water before the elements
are switched on. As this unit has electronic
control, it is vital that the commissioning
procedure is followed. Failure to carry out
this operation will result in damage to the
unit and will invalidate the guarantee.
Replacement parts can be ordered from Customer
Service. See
‘spare parts’
for details and part numbers.
Due to continuous improvement and updating,
specification may be altered without prior notice.
