Bezique
Place the rail onto the installed lower bracket.
Replace the upper bracket onto the rail and
secure the bracket to the wall with the screws
supplied
(fig.)
.
Place a trim cover onto each bracket. Make
sure the large tab at the narrow end of the trim
cover engages into the slot between the rail and
bracket
(fig.)
before pushing and clicking the
other end into place.
Should the need arise, the trim covers can be
removed by inserting a screwdriver into the slot
and carefully levering off the trim.
Snap the soap dish onto the rail
(fig.)
below
the holder assembly. Prise open the soap dish
collar and fit onto the rail
(fig.9)
below the
dish. The collar is slightly tapered and should be
fitted ‘thinner section’ uppermost. Make sure it
locates firmly in the soap dish so it holds the dish
at the required height on the rail.
fiTTiNG THE HOSE aND
SHOWErHEaD
Feed the flexible hose through the appropriate
soap dish opening
(fig.0)
so that the dish acts
as a retaining ring (Water Regulations).
Screw the flexible hose to the shower outlet and
showerhead
(fig.)
, making sure the supplied
washers are in place at both ends of the flexible
hose.
Place the showerhead into the holder
(fig.)
and check that it fits correctly.
Note:
The holder is slightly tapered and the
showerhead and hose will only fit from one
direction.
Note:
The holder ratchet system will not move
until the showerhead is in place.
ImpoRtANt:
It is the conical end of the hose
which grips into the holder. the showerhead
will not fit in the holder without the hose
attached.
At this stage, disconnect the showerhead and
lay to one side until the shower unit has been
commissioned.
Fig.
Thin section at top
Fig.0
Showerhead
Holder
Washers
Shower
Showerhead
Fig.
Fig.
Fig.9
Fig.
