Bezique
low pressure
power
Stop
button
Temperature
control
Economy
Cold
High
OPEraTiNG THE SHOWEr
When the electricity supply to the shower is
switched on at the isolating switch, the POWER
indicator will light.
To start the shower
Water will flow by pressing any of the three
buttons — COLD, ECOnOMY or HIGH.
To stop the shower
Press the STOP button and the phased shutdown
will begin. Water will cease to flow after about
four seconds.
To use the control buttons
There are three control buttons — high, cold
and economy
(fig.)
.
The upper button — red symbol
is a high
power setting which allows the highest flow
achievable for your preferred temperature. This
setting should normally be regarded as optimum
shower performance throughout the year.
Temperature adjustment at this setting is via the
temperature control.
The centre button — blue symbol
is for cold
water only. Adjusting the temperature control
at this setting will only increase or decrease the
force of the water from the showerhead. (It will
not alter the water temperature).
The lower button — red symbol
is an
economy setting for using less energy when the
ambient mains water temperature is high during
hot months. Temperature adjustment at this
setting is via the temperature control.
Note:
If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
Fig.
Note:
In normal use, it is in order to leave the
water supply permanently on to the shower
unit, but as with most electrical appliances,
the unit must be switched off at the
isolating switch when not in use.
WARNING!
before normal operation of the
shower, it is essential that the
commissioning procedure has been
completed correctly.
