Bezique
0
PlumBiNG CONNECTiONS
Plumbing to be carried out before wiring
DO nOT use jointing compounds on any pipe
fittings for the installation.
DO nOT solder fittings near the shower unit
as heat can transfer along the pipework and
damage components.
Compression fittings MUST
be used to connect
to the inlet of the shower. (Push-on fittings must
nOT be used as full engagement cannot be
guaranteed).
Note:
An additional stopvalve (complying with
Water Regulations) MUST be fitted in the mains
water supply to the shower as an independent
means of isolating the water supply should
maintenance or servicing be necessary.
ImpoRtANt:
Before completing the
connection of the water supply to the inlet
of the shower, flush out the pipework to
remove all swarf and system debris. this can
be achieved by connecting a hose to the
pipework and turning on the mains water
supply long enough to clear the debris to
waste.
Procedure
Turn off water supply either at the mains
stopvalve or the isolating stopvalve. Connect the
mains water supply to the inlet of the shower
via 15mm copper, stainless steel or plastic pipe
using a 15mm x 15mm elbow compression
fitting.
DO nOT use excessive force when making these
connections.
Make sure the backplate is square on the wall
and tighten the two retaining screws which hold
it to the wall.
Turn on the mains water supply and check for
leaks in the pipework connection to the shower.
Note:
At this stage no water can flow through
the unit.
WARNING!
the outlet of the shower acts as a
vent and must Not be connected to
anything other than the hose and
showerhead supplied.
