Installation
(for qualified installers only)
1 3
© Travis Industries
4080207
100-01185_000
Converting the Fireplace to Rear Vent (continued)
AAAA
AAAA
AAAA
Attach the cover plate to
the top of the fireplace.
NOTE: You will need to
tuck the front edge of the
cover plate under the upper
standoff.
Bend the heat
shield as shown
to the right.
Remove the 4 screws on the angled
top of the fireplace and attach the heat
shield with these screws.
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
Attach the inner flue
assembly with four
screws (make sure
the gasket is in place
while attaching).
NOTE: Install the flue
assembly with the diffuser
to the bottom.
Attach the outer
flue assembly
with four screws
(make sure the
gasket is in place
while attaching).
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
Flatten the exhaust restrictor following
the steps shown below.
