Installing and Connecting an Indoor MP
Installing an Indoor MP
Installing and Connecting an Indoor MP
2 – 7
7. Install the universal mounting bracket as follows onto the T-bar or T-bar clamp:
a. As shown in
Figure 2–6
, place the universal mounting bracket against the T-bar or clamp
so that the two screw holes face downward and the two T-bar flanges face upward and are
adjacent to the T-bar edges.
Figure 2–6. Step 7—Top View
b. Properly align the bracket for mounting by placing the bracket so the port connector opening
is to the left of the hole you cut for the cables.
c. Rotate the universal mounting bracket clockwise until the flanges snap into place on the
T-bar or clamp as shown in
Figure 2–7
.
Figure 2–7. Step 7—Bottom View
8. Pull the Cat 5 cable(s) about 6 inches (about 15 cm) out of the hole in the ceiling tile and
through the port connector opening to create enough slack to insert the cable(s).
9. Insert the Cat 5 cable(s) into the connector(s):
❑
For a single connection, use the connector for port 1.
❑
For redundancy, insert one cable into each connector.
10. Install the Kensington lock, if you plan to use one.
a. Loop the Kensington lock cable around an object that cannot be moved or damaged by a
person pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the MP.
d. Rotate the key right or left to secure the lock to the MP.
T-bar
(Viewed from above ceiling tiles, looking down.)
Universal mounting
bracket
Port connector
opening
T-bar
Universal mounting bracket
Port connector
opening
