Installing and Connecting an Indoor MP
Installing an Indoor MP
Installing and Connecting an Indoor MP
2 – 11
Figure 2–14. Step 6—Top View
Figure 2–15. Step 6—Bottom View
7. Pull the Cat 5 cable(s) about 6 inches (about 15 cm) out of the hole in the ceiling tile and
through the port connector opening to create enough slack to insert the cable(s).
8. Insert the Cat 5 cable(s) into the connector(s):
❑
For a single connection, use the connector for port 1.
❑
For redundancy, insert one cable into each connector.
9. Install the Kensington lock, if you plan to use one.
a. Loop the Kensington lock cable around an object that cannot be moved or damaged by a
person pulling on the cable.
b. Insert the key into the Kensington lock.
c. Insert the Kensington lock into the security slot on the MP.
d. Rotate the key right or left to secure the lock to the MP.
e. Pull on the lock to verify that it is secured to the MP.
f. Remove the key.
10. Lift the MP into place on the universal mounting bracket as shown in
Figure 2–16
.
Make sure the cable feeds properly into the ceiling as you lift the device, and does not become
trapped between the MP and the bracket.
T- bar
T-bar clamps
(attached
to T-bar)
Universal mounting
bracket
(Viewed from above ceiling tiles, looking down.)
Port connector
opening
T-bar
Universal mounting bracket
Port connector
opening