Trane AFDR, Руководство по установке

Страница: 61 / 72

Installation
AFDR-SVN001D-EN 61
Retrofit Air-Cooled RTHD
Adaptive Frequency Drive Model
AFDR (TR200) Installation and Startup
Most of the drive parameters are already set up when the
drive is shipped except for a short list of unit specific
parameters obtained from the unit and motor nameplates
that need to be field programmed.
Important: When confirming these parameters it
is important that [0-03 Regional
settings] be left in the “North
American” category.
Do NOT change this
default setting.
Refer to Table 17 for a list of items that are programmed in
the drive at the factory for use with Trane chillers. In the
event that the drive needs to be reset, these parameters
need to be reprogrammed into the drive.
To reset the drive to the Danfoss defaults, perform the
following procedure.
1. Disconnect power to the drive, and wait for the display
to shut down.
2. While powering up the drive, press and hold the
following keys: Status , Main , and OK .
3. After 5 seconds, release the keys.
After the drive is reset , reprogram the items listed in
Table 17 .
Important: These parameters are supposed to have
been set at the factory to the Trane-specific
values shown here in
Table 17 . Always
confirm before actual drive start up that this
is so and correct any one of the parameter
settings as necessary.
NOTICE:
Compressor Damage!
Improper drive parameter settings could cause
compressor damage or failure. Verify drive parameters
are set correctly prior to unit operation.
Table 16. Compressor specific parameters (motor frame/voltage/Hertz)
ID Description
B1/B2 C1/C2 D1/D2/D3
460V/60 Hz 575V/60 Hz 460V/60 Hz 575V/60Hz 460V/60Hz 575V/60Hz
1-21 Motor Power 233HP 233HP 334HP 334HP 441HP 441HP
1-22 Motor Voltage 460V 575V 460V 575V 460V 575V
1-23 Motor Frequency 60Hz 60Hz 60Hz 60Hz 60Hz 60Hz
1-24 Motor Current Output Amps value from new AFDR nameplate sticker; refer to Figure 88, p. 55 .
1-25 Motor Nom Speed 3512RPM 3512RPM 3531RPM 3531RPM 3535RPM 3535RPM
1-30 Stator Resistance 0.0303 Ω 0.0430 Ω 0.0201 Ω 0.0308 Ω 0.0122 Ω 0.0197 Ω
1-31 Rotor Resistance 0.0257 Ω 0.0365 Ω 0.0146 Ω 0.0227 Ω 0.0091 Ω 0.0144 Ω
1-35 Main Reactance 5.3684 Ω 8.0570 Ω 3.0050 Ω 4.8857 Ω 2.8882 Ω 4.8553 Ω
1-36 Fe Loss Resistance 188.388 Ω 280.730 Ω 152.612 Ω 243.610 Ω 125.549 Ω 193.850 Ω
3-03 Max Reference 60Hz 60Hz 60Hz 60Hz 60Hz 60Hz
4-14 Mtr Spd High Lim. 60Hz 60Hz 60Hz 60Hz 60Hz 60Hz
14-11 Volt at Mains Fault 391V 489V 391V 489V 391V 489V