User Manual
THIS DOCUMENT IS UNCONTROLLED WHEN PRINTED
Page
33
of
34
Remote control distance is too short:
Possible issue
Guidelines
Antenna coaxial connection to
main PCB
•
Check Antenna is securely tightened to unit.
•
Open Control panel and check that the Antenna SMA connection is firmly tightened on the
main PCB.
Remote control battery power is
low
•
Open the remote control casing and replace with a new same type battery.
Battery charge lights not illuminating on control panel:
Possible issue
Guidelines
Lead not working or plugged in
correctly
•
Ensure the battery charger lead is securely connected to the rear of the 240V outlet
located below the charger to the right.
•
Check to ensure the charging lead is securely connected to the 240V external outlet
located to the left of the unit above the rear wheels.
•
Check that the charging lead is firmly connected to the power point and the power point is
turned on.
•
Check lead to ensure no exposed wiring on the lead and that the leads test and tag label is
in date
–
If not replace the lead.
Boom arm motion not smooth:
Possible issue
Guidelines
Spring tension not optimal
•
Tighten spring located inside the casing
–
Spring is attached to the mechanical arm and
the base of the unit with threaded rods and fixed into place with double nuts top and
bottom. To tension the spring ensure Arm is vertical then loosen the nuts on either end of
the threaded rods
–
pull top threaded rod up and bottom threaded rod down then hand
tighten nuts
–
test arm movement
–
Arm movement should now be smooth - Lock
threaded rods in place by tightening the double nuts at the top and bottom with a
spanner.
Arm movement loose
•
Ensure billet locking nut is tightened
–
Locking nut is located on the external shaft and is
used to ensure the Arm stays firmly in place during up and down movement.
Remote pairing:
Possible issue
Guidelines
Remote not paired
•
Unscrew the Control Panel. At the back of the control panel, fitted to the main PCB is a
smaller PCB fitted at a right angle
–
This is the receiver PCB for the remote controls
–
on
the PCB there are two channels
–
Channel A closer to the perimeter of the PCB and
Channel B positioned further into the middle of the PCB
–
both have black buttons
–
Remotes are paired to CHANNEL B only
–
To program a remote press and hold the
Channel B black button and at the same time press the button on the remote control
–
An
LED near the Channel B button will initially turn RED then once paired will turn green
–
Once the LED turns green cease pressing the channel B button and the push button on the
remote control
–
Once the LED turns green the remote has been paired successfully.
Bounce back function not working:
Possible issue
Guidelines
Amperage switch set to low
•
Open Control Panel and adjust “BLUE” amperage switch
clockwise located on the on main
PCB.
