User Manual
THIS DOCUMENT IS UNCONTROLLED WHEN PRINTED
Page
10
of
34
•
Secure wheels using locking mechanism.
•
Ensure product is switched off prior to fitting any components.
STEP 3
–
Attach boom arm to product:
•
Check for overhead and surrounding obstructions prior to fitting the boom arm.
•
Position the boom arm at a 45 degree angle and slide the billet into connection shaft.
•
Push the boom arm upward into the vertical position, this will create the connection.
•
Pull the arm away from the product (towards body) to lock the connection.
•
Tighten connection shaft locking nut by turning counter clockwise, hand tighten only.
STEP 4
–
Extending the boom arm:
•
Loosen the extension wing nuts and extend the boom arm to the desired length.
•
Tighten the wing nuts to secure the extension position.
•
Note that the arrow markers on the extension are an indication of road widths.
STEP 5
–
Attach stop sign to boom arm:
•
Position the stop sign at the end of the fixed boom arm.
•
If using the LED
boom light, ensure the stop sign doesn’t obstruct the LED light.
•
If the arm is being extended, ensure the straps are fitted to the fixed and extension arm.
•
Ensure straps are secure and the stop sign is displaying correctly.
STEP 6
–
Stabilise the product and secure:
•
Ensure the product is positioned on a level and stable surface.
•
Loosen wingnut all the way back, slide stabilising leg into position.
•
Ensure all stabilising legs are used and that the rubber stopper is firmly on the ground.
•
Secure position by tightening the wing nuts.
STEP 7
–
Use of S hooks and sandbags:
•
If additional stability is required, insert S hooks into holes under each stabilising leg.
•
Affix sandbags to the S hooks.
WARNING
•
Never use excessive force or tools to fit the boom arm onto the shaft.
•
Keep shaft clean and ensure that no grease or similar products is applied onto the shaft.
•
Ensure product is switched off prior to fitting any component or making adjustments.
•
Ensure control panels are locked and keys removed to prevent tampering or theft.
•
Ensure billet is locked into place prior to use, if the product is going to in position for long
term periods, period checks should be conducted.
•
Avoid affixing the stop sign straps over the wing nuts to prevent damage to the straps.
•
Product is wind rated, ensure sandbags are used to provide additional stability.
•
Product is 100kg and is considered to be a crush hazard, ensure use on level surface.
•
It is recommended that manual aid be used if lifting the product.
•
Keep fingers clear of any moving parts and wear gloves when assembling.
