User Manual
THIS DOCUMENT IS UNCONTROLLED WHEN PRINTED
Page
16
of
34
6.
Retrofit of PB2000 for accessories
6.1.
Retrofit requirements
In order for the PB2000 product to be able to operate the accessories, a retrofit of the product is
required. The retrofit must be carried out by an approved service technician, the distributor or
returned to base.
6.2.
Universal attachment
The PB2000 requires an adapter unit to be retrofitted to the product in order to secure and operate
the accessories. The universal attachment is used for traffic / pedestrian lights and the solar panel.
STEP 1
–
Unpack the accessory and check components:
•
Check the condition of the accessory to ensure all components have been supplied.
STEP 2
–
Retrofit the adapter:
•
Remove screws at either end of the handle and detach.
•
Position the universal attachment in the handle cavity and line up the screw holes.
•
Install screws at either end of the attachments (as shown).
•
Attach original handle to the adapter, install screws at either end of the handle.
6.3.
Hardware and software
Additional hardware and software upgrades are also required to enable and enhance the PB2000 to
the same capacity as the PB2000L, including:
•
Control panel upgrade;
•
Port and connection installation;
•
Motherboard upgrade;
•
Software upgrade; and
•
Battery upgrade.
Refer to section 7 for details on the accessories. Please contact the distributor or us directly to
discuss upgrade options.
