User Manual
THIS DOCUMENT IS UNCONTROLLED WHEN PRINTED
Page
27
of
34
7.10.
Activation sensor
The activation sensor is an alternative to the GSM phone and key pad entry systems. It may be
applied at sites where authorisation at the access point is not required or controlled.
STEP 1
–
Unpack the accessory and check components:
•
Check the condition of the accessory to ensure all components have been supplied.
STEP 2
–
Connect accessory cable to connection port:
•
Ensure the product is turned off prior to connecting cable.
•
Connect cable and plug into the activation sensor (AS) connection socket.
•
Ensure plug is pushed in and fully connected.
STEP 3
–
Positioning the accessory:
•
Position the both bollards in close proximity to the product (radius no greater than 4m).
•
Ensure the reflector bollard is aligned opposite the sensor fitted to the product.
•
Ensure the activation sensor light turns green, if it turns red, realignment is required.
•
Ensure the bollard is on a flat surface and secured to the ground to prevent it from falling.
•
Position cable so that is cannot be damaged or create a tripping hazard.
STEP 4
–
Test and operate accessory:
•
Access the control panel using the key.
•
Turn the safety sensor (SS) switch on by pressing the switch up.
•
Activate the product on by switching the power button on.
•
The product will run a self-test, once complete the green power light will illuminate.
•
Test attachment in manual mode by pressing the red button and using the remote control.
•
Obstruct/break the beam to activate the boom.
