Printed in the Federal Republic of Germany
TR-Electronic GmbH 2011, All Rights Reserved
06/28/2017
TR - ECE - BA - DGB - 0084 - 05
Page 45 of 55
4.1.2.1 Total number of steps
Defines the
total number of steps
of the measuring system before the measuring
system restarts at zero.
CE_-65
CO_-65
lower limit
2 steps
2 steps
upper limit
1073741824 steps
33554432000 steps
default
16777216 steps
16777216 steps
The actual upper limit for the measurement length to be entered in steps is dependent
on the measuring system version and can be calculated with the formula below. As
the value "0" is already counted as a step, the end value = Total number of steps – 1.
Total number of steps = Number of steps per revolution * Number of revolutions
To calculate, the parameters
Number of steps per revolution
and the
Number of
revolutions
can be read on the measuring system nameplate.
4.1.2.2 Revolutions numerator / Revolutions denominator
Together, these two parameters define the
Number of revolutions
before the
measuring system restarts at zero.
As decimal numbers are not always finite (as is e.g. 3.4), but they may have an infinite
number of digits after the decimal point (e.g. 3.43535355358774...) ) the number of
revolutions is entered as a fraction. However, the fraction mustn't be smaller than 0.5.
numerator lower limit
1
numerator upper limit
256000
default numerator
4096
denominator lower limit
1
denominator upper limit
16384
default denominator
1
Formula for gearbox calculation:
Total number of steps = Number of steps per revolution *
Number of revolutions numerator
Number of revolutions denominator
