ZK1800
SWING GATE OPERATOR USER’S MANUAL
11
Fig.10 Fig.11
Move the front part of gate operator up and down slowly, check the installation height of the
gate bracket, fit the gate bracket to the gate, and the centerline of the gate bracket should
align with the vertical line, and use a level to check the flatness of the operator (See Fig.12).
Tack weld the gate bracket on the gate, the bracket installation should meet the specifications
as shown in Fig.1 and Fig.2.
Release the gate operator, open and close the gate manually, performing complete opening
and closing travel. Movement must be smooth and the lead screw socket, should not reach
the mechanical stop.
If this is not the case, review bracket positioning and that its dimensions conform to those
listed in the specifications of this document.
After you have identified the desired position of the bracket, remove the gate operator and
permanently weld the gate bracket top, bottom and sides. See Fig.13.
Install the gate operator as shown in Fig.14.
Caution: welding with operator in place may damage the operator.
Fig.12 Fig.13
Circlip
4
2
1
3
Rear part of gate operator
Pin
Post bracket
1
2
3
4
3
2
1
1
2
3
Front part of gate
operator
Gate bracket
Lock nut M12
Move the front part of gate operator up and down
and check the position of gate bracket with a
level, make sure that the gate operator is level.
Remove the gate operator, weld
the gate bracket on the gate.
