Total Door Automation ZK1800, Руководство пользователя

Страница: 22 / 24

ZK1800
SWING GATE OPERATOR USER’S MANUAL
22
11. Electrical / Setting
Learn / erase remote controls
Adding extra remote controls (Learn):

Press the
‘LEARN’ button on the control board (see Fig.24 No.7), then the green indicator
‘LED2’ (see Fig.24 No.6) will be on.

Press the remote control button which you want to use, the
‘LED2’ will turn off.
 Press the same button again, the ‘LED2’ will flash about 5 seconds at 2Hz frequency. The
learning process is finished.

Up to 25 remote controls may be used.
To erase all remote controls
 Press and hold the ‘LEARN’ button on the control board until ‘LED2’ turns on and then turns
off. This indicates that all the remote controls have been erased completely.

The remote control works in a single channel mode. With each press of the remote control
button which has been programmed, the gate will close, stop, open or stop cycle.
Warning: Notify the users that the gate is never to be operated unless it is in full view.
For safety and security, we recommend that the factory setting be replaced with a personal
code.
Auto-stop function

Slowly rotating the
sensitivity sensor ‘FORCE ADJ’ (see Fig.24 No.1 and No.2) with a
screwdriver, 1# sensor can be used to adjust primary operator, 2# sensor can be used to
adjust secondary operator.

Rotating the sensor clockwise increases the force. Rotating the sensor anticlockwise
decrease the force.

Place an immobile object along the gate path, allowing the gate to strike it while in the open
or close cycle. The gate will stop if obstructed when closing or opening.

If it does not, increase or decrease the force and repeat this test. Repeat the steps until the
correct force has been set.

Operators must be individually adjusted, repeat the steps as above for the secondary
operator using the 2# sensor.
Auto-close function

Place the jumper cap on both pins of terminal
‘SW’ see Fig.24, No.9, the gates will stay open
for 30
±
3 seconds before automatically closing.

Remove the jumper cap or place the jumper ca
p on one pin of terminal ‘SW’, the auto-close
function is shut off.
An Infrared device is required to be installed for safety if the auto-close feature is enabled.
Factory preset: the auto-close function is shut off.