Total Door Automation ZK1800, Руководство пользователя

Страница: 21 / 24

ZK1800
SWING GATE OPERATOR USER’S MANUAL
21
Infrared photocell (Normally open)
If the infrared beam is interrupted during closing, the gates will reverse and open immediately.
During opening, the beeper will ring.
Connect signal wire of infrared device to ‘IR’ (see Fig.28 terminal X6), connect common wire (i.e.
‘power supply –‘) of infrared device to ‘COM’, and connect ‘power supply +’ of infrared device to
‘12V’.
The control box is not factory equipped with an infrared device. The infrared device can be obtained
through your dealer.
12V
IR
COM
X6
Connection of infrared photocells
+12V Signal
Photocell receiver
Photocell transmitter
+12V COM COM
Fig.28
Install the external button switch (Normally open)
The ZK1800 is equipped with an interface for an external button switch or keypad.
To install the keypad attach two wires
of your keypad to the ‘O/S/C’ terminal. The keypad will
function in single channel mode.
For three-button switch installation, use the terminals for multi-
channel mode. The port ‘COM’ is the
common port, the port ‘K’ is used to open the gate, ‘G’ is used to close the gate, and ‘T’ is used to
stop the gate. (See Fig.29 terminal X7)
COM K T G
X7
O/S/C
keypad
External button switch
(Three-button mode)
Com Open Stop Close
Connection of external button switch
Fig.29