Toshiba E-studio 281c, Руководство по печати

Страница: 195 / 382

Setting Up the UNIX Filters 193
Configuring the Print Queue
After you copy UNIX Filters, you can configure the print queue.
There are two ways to configure the print queue: one is creating a print queue using estcolo-
radd, and the other is creating a print queue manually without using estcoloradd.
P.193 “Creating a Print Queue Using estcoloradd”
P.193 “Creating a Print Queue Manually”
— Creating a Print Queue Using estcoloradd
You can create a print queue using estcoloradd.
Creating a print queue
1
Log on to the root account.
2
Enter the following command:
estcoloradd <queue name> <host name or IP address>
y This command creates a print queue using the system’s lpadmin command. It also
creates a configuration file that has the destination IP address or host name. Use the
configuration file to change print queue parameters.
y The lpadmin command stores the printer interface file in the /etc/lp/interfaces direc-
tory in a file with the same name as the print queue. The configuration file is stored in
the /etc/lp/interfaces directory in a file named <queue name>.conf.
y Under Linux, the printtool (or equivalent) utility must be used to add the printer into
the lp printing system after executing the est coloradd command.
— Creating a Print Queue Manually
You can also configure the print queue by adding a remote printer manually.
The procedure varies depending on the operating systems.
P.193 “Creating a print queue manually on Solaris”
P.194 “Creating a print queue manually on HP-UX”
P.195 “Creating a print queue manually on IBX AIX”
P.195 “Creating a print queue manually on Linux”
P.196 “Creating a print queue manually on OpenUNIX”
Creating a print queue manually on Solaris
1
Log on to the root account.
2
Open your Linux/UNIX editor.
3
Create the following file.
/etc/lp/interfaces/<queue name>.conf
4
Add a line as below in the <queue name>.conf.
dest=<IP address>
5
Save the file.