Storage
Cleaning and Storage
1.
Disengage the blade control switch, move the motion
controls outward to the park position, stop the engine,
and remove the key.
2.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine cylinder head fins and blower housing.
Important:
You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
3.
Service the air cleaner; refer to Servicing the Air
Cleaner in the Engine Maintenance section.
4.
Grease and oil the machine; refer to the Lubrication
section.
5.
Change the crankcase oil and filter; refer to Servicing
the Engine Oil in the Engine Maintenance section.
6.
Check the tire pressure; refer to Checking the Tire
Pressure in the Drive System Maintenance section.
7.
Charge the battery; refer to Servicing the Battery in the
Electrical System Maintenance section.
8.
Check the condition of the blades; refer to Servicing
the Cutting Blades in the Mower Maintenance section.
9.
Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows.
10.
Add a petroleum based stabilizer/conditioner to the
fuel in the tank. Follow the mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note:
A fuel stabilizer/conditioner is most effective
when mixed with fresh gasoline and used at all times.
Run the engine to distribute the conditioned fuel
through the fuel system (5 minutes).
Stop the engine, allow it to cool, and drain the fuel tank.
Restart the engine and run it until it stops.
Choke the engine. Start and run the engine until it will
not start.
Dispose of fuel properly. Recycle pursuant to local
codes.
Important:
Do not store stabilizer/conditioned
gasoline over 30 days.
11.
Remove the spark plug(s) and check its condition; refer
to Servicing the Spark Plug in the Engine Maintenance
section. With the spark plug(s) removed from the
engine, pour two tablespoons of engine oil into the
spark plug hole. Use the starter to crank the engine and
distribute the oil inside the cylinder. Install the spark
plug(s). Do not install the wire on the spark plug(s).
12.
Clean any dirt and chaff from the top of the mower.
13.
Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
14.
Check the condition of the drive and mower belts.
15.
Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is worn or damaged.
16.
Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
17.
Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
49
Содержание TimeCutter ZS 4200
