Toro 74901 Z Master 5000, Руководство оператора

Страница: 49 / 68

Figure 75
Left Hand Brake Shown
1. Cable anchor 5. Caliper
2. Hold threaded rod here
6. Compression spring
3. Measure 7. Threaded rod
4. Lock nut 8. Hub
10. Disengage the park brake. Turn the wheel hub by hand
in both directions relative to the caliper; no drag of the
caliper pad on the wheel hub is desired.
11. If there is no movement between the hub and the
caliper then repeat the adjustment (drive release valves
must be in the
released position on the hydros).
12. After adjusting the brakes on both sides of the mower,
cycle the brake handle a minimum of six times to allow
the cable to seat into the sheath and mounting tabs.
13. Recheck the spring length; engage the park brake and
repeat steps 8 through 11 if the length is not in the
correct range.
14. Rotate the drive wheel release handle to the operating
position. Refer to the Using the Drive Wheel
Release Valves section in Operation.
15. Install the rear tires and torque lug nuts between 90 and
95 ft-lb (122 and 129 N-m).
16. Remove jack stands.
Belt Maintenance
Inspecting the Belts
Service Interval: Every 50 hours
Check the belts for squealing when the belt is rotating, blades
slipping when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn mower belt. Replace the mower
belt if any of these conditions are evident.
Replacing the Mower Belt
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks are
signs of a worn mower belt. Replace the mower belt if any of
these conditions are evident.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Lower the mower to the 3 inch (76mm)height of cut.
4. Remove the belt covers (Figure 76).
G009036
1
2
Figure 76
1. Push tab down 2. Remove belt cover
5. Use a ratchet in the square hole in the idler arm to
remove tension on the idler spring (Figure 77).
6. Remove the belt from the mower deck pulleys.
7. Remove the belt guide on the spring loaded idler arm
shown in Figure 77.
8. Remove the existing belt.
9. Install the new belt around the mower pulleys and the
clutch pulley under the engine (Figure 77).
49