5.
Move the throttle lever midway between the Slow and
Fast positions.
g017006
Figure 19
6.
Turn the ignition key to the Start position (Figure 17).
When the engines starts, release the key.
Important:
Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 20
1.
Off
3.
Start
2.
Run
Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Let the engine idle at slow throttle (turtle) for 60 seconds
before turning the ignition switch off.
g017007
Figure 21
Important:
Make sure that the fuel shut off valve is
closed before transporting or storing the machine, as
fuel leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel
pump may run and cause the battery to lose charge.
19
Содержание 74901 Z Master 5000
Страница 28: ...Figure 40 1 Trailer 3 Not greater than 15 degrees 2 Full width ramp 4 Full width ramp side view 28 ...
Страница 66: ...Schematics Wire Diagram Rev A 66 ...
Страница 67: ...Notes 67 ...