Installing the Rear Lights
1.
Align the holes of the rear-light bracket with the 2
holes in the center-boom channel.
Note:
The left and right rear-light bracket are unique.
Ensure that the short flange of the bracket is flush with
the surface of the channel.
Figure 10
Left bracket installation shown; right bracket installation
is similar
1.
Flanged-head bolt (5/16 x
3/4 inch)
3.
Locknut (5/16 inch)
2.
Rear-light bracket (left
bracket shown)
4.
Boom-frame channel
2.
Secure the bracket to the frame with the 2 flanged-head
bolts (5/16 x 3/4 inch) and 2 locknuts (5/16 inch) as
shown in
3.
Repeat steps
and
for the other rear-light bracket at
the other end of the center-boom channel.
4.
Align the rear-light assembly to the rear-light bracket
with the amber-lens outboard (
).
Figure 11
1.
Rear-light assembly
2.
Rear-light bracket
5.
Secure the rear-light assembly to the bracket with the 2
nuts (5/16-18) and the 2 lock washers that are provided
with the light assembly.
6.
Repeat steps
and
at the other rear-light bracket at
the other end of the center-boom channel.
4
Installing the Speed Signs and
License Plate Brackets
Parts needed for this procedure:
3
Decal
1
Speed sign
2
Flange-head bolts (5/16 x 3/4 inch)
2
Flange locknuts (5/16 inch)
Installing the Speed Decal the Sprayer
Tank
1.
At the left and right sides of the tank, measure from
the top of the sprayer tank downward approximately
120 mm (4-3/4 inches) and mark that location on the
tank with a piece of tape (A of
).
Figure 12
1.
Top of the tank to the
edge of the tape—120 mm
(4-3/4 inches)
2.
Front of the tank to the
edge of the tape—469 mm
(18-7/16 inches)
2.
At the left and right sides of the tank, measure from
the front of the sprayer tank rearward approximately
469 mm (18-7/16 inches) and mark that location on
the tank with a piece of tape (A of
).
7