
Figure 37
1.
Wire harness
3.
4-socket connector (
LEFT
REAR TURN
/
BRAKE SIGNAL
)
2.
Boom-valve bracket
4.
Route the wire harness to the left of the flow meter and
toward the boom-frame channel (
).
Figure 38
1.
4-socket connector (
LEFT
REAR TURN
/
BRAKE SIGNAL
)
3.
4-socket connector (
RIGHT
REAR TURN
/
BRAKE SIGNAL
)
2.
Bullet connectors (
LICENSE
LIGHT
)
5.
Route the 2 bullet connectors labeled
LICENSE LIGHT
through the 25 mm (1 inch) hole in the license-plate
bracket (
).
6.
Connect the 4-socket connector of the wire harness to
the 4-pin connector of the tail-light lead (
).
Figure 39
1.
Tail light
3.
4-pin connector
2.
4-socket connector
7.
Repeat step
for the other tail light.
10
Installing the License-Plate
Light
Parts needed for this procedure:
1
License-plate light
1
Screw (#10 x 5/8 inch)
2
Locknut (#10)
Procedure
1.
Insert the 2 bullet connectors labeled
LICENSE LIGHT
into the 2 sockets of the license-plate light (
Figure 40
1.
License-plate light
3.
Bullet connector (labeled
LICENSE LIGHT
)
2.
Socket
17