Toro 41250, Руководство по установке, Страница: 11 / 32

Figure 19
1. Turn-signal switch 3. Hose clamp
2. Steering-wheel valve
7
Installing the Horn
Parts needed for this procedure:
1 Horn assembly
1 90° bracket
1 Flange-head screw (5/16 x 3/4 inch)
1
Flange locknut (5/16)
Procedure
1. Remove the nut and 90° bracket from the horn
assembly (
Figure 20 ).
Figure 20
1. Horn 3. Nut
2. 90° bracket
2. Rotate the 90° bracket as shown in Figure 20 and
loosely secure it to the mounting stud of the horn
assembly with the nut that you removed in step
1 .
Note:
You will tighten the nut of the horn assemble
in a later procedure.
3. Align the hole in the short leg of the 90° bracket with
the hole in the rear-platform channel (
Figure 21 ).
4. Assemble the 90° bracket to the platform channel with
the flange-head screw (5/16 x 3/4 inch) and the flange
locknut (5/16) as shown in
Figure 21 .
Figure 21
1. Horn assembly 3. Flange locknut (5/16)
2. Flange-head screw (5/16
x 3/4 inch)
5. Torque the flange-head screw and flange locknut to
198 to 254∙N∙m(175 to 225 in-lb).
11