
8.
Fully insert the clevis pin through the holes in the seat
latch and the inboard-seat gusset.
9.
Secure the lock bracket to the outboard-seat gusset
with the hex-head screw (12 x 20 mm) and the locknut
(12 mm) as shown in
Figure 60
1.
Hex-head screw (12 x 30
mm)
3.
Outboard-seat gusset
2.
Lock bracket
4.
Locknut (12 mm)
15
Installing the Seat
No Parts Required
Procedure
1.
Ensure that the grip of the lock-mount bracket and the
latch is facing up (
Note:
If the grip is not in the right position, put a
screw driver into the slot of the latch and rotate the
grip upward.
Figure 61
1.
Lock-mount bracket
3.
Grip
2.
Latch
2.
Align the seat and seat pan with the holes in the
machine frame where the seat was removed (
).
Figure 62
1.
Seat and seat pan
3.
Insert the 2 pivot pins that secure the seat and seat pan
to the chassis (
Figure 63
1.
Hairpin
4.
Pivot pin
2.
Pivot fitting (seat pan)
5.
Seat pan
3.
Chassis bracket
4.
Insert the 2 hairpins that secure the pivot fitting of the
seat pan to the chassis brackets (
).
5.
Connect the electrical connector of the chassis harness
to the seat-switch connector (
Figure 64
1.
Connector (chassis
harness)
2.
Seat-switch connector
6.
Lower the seat and latch it to the seat pan.
23