
2.
Align the lens for the light down and the holes in the
light with the holes in the license-plate bracket (
Figure 41
1.
License-plate light
3.
Screw (#10 x 5/8 inch)
2.
Locknut (#10)
4.
License-plate bracket
3.
Assemble the light to the bracket (
) with the 2
screws (#10 x 5/8 inch) and 2 locknuts (#10).
Note:
Ensure that the wires are not pinched between
the light and the license-plate bracket.
11
Installing the Hazard Switch
Parts needed for this procedure:
1
Hazard switch
Procedure
1.
Remove the hole plug for the hazard switch from the
control panel on the side-console mount (
).
Figure 42
1.
Hole plug
2.
Side-console mount
2.
Route the 8-socket connector of the wire harness
through the hole in the side-console mount (
).
Figure 43
1.
8-socket connector
2.
Hole in the side-console
mount
3.
Connect the 8-socket connector of the wire harness to
the 8-blade connector of the hazard switch (
).
Figure 44
1.
8-socket connector
2.
Hazard switch (8-blade
connector)
18