TOPEX BYTTON HSDPA
User’s Manual
pag. 65
5.8. VOICE
Configure the phone interface and routing of calls.
There are two configuration pages in the voice section:
Settings
, which allows you to select the priority of voice calls, type of the phone interface and the
routing of incoming calls (target, DISA, extension);
Status
, which shows the current state of the voice interface of your Bytton device (on hook, in call,
stopped, and so on).
To understand these settings, you must first review the modes of connecting BYTTON to a PBX or a
phone.
5.8.1. Phone Connections for BYTTON HSDPA
The telephony interfaces of BYTTON HSDPA can be connected in several ways:
-
to an analogue trunk of a PBX exchange
-
directly to an analogue phone
-
to a local interface (office subscriber) of PBX exchange
For this purpose BYTTON HSDPA has two interfaces with RJ11 connectors, one is for FxO connection
and the other for FxS connection.
Only
one of them
may be connected at any moment of time!
The selection is done through the Web interface, in the “PHONE” subsection, where you must set the
phone line interface
either
as FXS or as FXO.
Connecting to a PBX trunk or a telephone
Use the FXS interface of BYTTON HSDPA (which must be activated from the Web configuration
page VOICE Settings), as shown in the drawing below:
