TOPEX BYTTON HSDPA
User’s Manual
pag. 34
5.2.3. Commit
The “Commit” option described here is not specific to LAN, but rather it is a general
option for the BYTTON equipment.
If you performed configuration changes, using the “Save” button is not enough since it
saves the modifications only into the temporary memory.
You should always press the “Commit” button if you want to make these changes
permanent.
This button is located at the bottom of the Menu list, to the left side of the
screen.
You will see a “Commit Settings” message and, underneath it, a ed progress bar which
says: “Saving changes, please wait …”
The message is really necessary, saving will take some times, because the changed
settings are saved into permanent (Flash) memory of the equipment.
Under the progress bar other messages are shown, indicating the used and respective
free memory of the equipment, and the stages of the operation: Unlocking, Erasing,
Writing …
BYTTON resets, and when it starts again, the new set of parameters will be active.
Warning!
While committing changes, when resetting Bytton or while loading a new program
image, the equipment will cease operation for a few seconds. This means all connections: data
link, voice, LAN and WiFi will be interrupted, then will resume when BYTTON starts again.
For instance, the status bar at the bottom of the
screen will temporary indicate that the LAN
connection with Bytton is not available (“cable
unplugged” or “limited connectivity” message and
connection icon with a red “x”:
Then Bytton HDSPA restarts with the new
parameters, and the LAN connection is immediately
restored.
