TOPEX BYTTON HSDPA
User’s Manual
pag. 57
5.5.6 Save
Makes a backup copy of the current configuration (all the settings you made) of the BYTTON equipment.
The configuration file is called by
default “CONF.tar”
You will see a message similar
to the one shown in this image
Click “Save” or select “Save it to disk” to save the file with the current configuration of BYTTON HSDPA.
You may select the folder where the configuration will be saved; also, you should change the default
name “conf.tar” into a name meaningful for your actual configuration.
Note
:
It is highly recommended that you backup your configuration from time to time. This way you can
always load the saved configuration, if there is need. For instance, when you perform a “Restore to
factory defaults”, all previous settings are lost. If you have saved the configuration, you can load it back
to perform changes.
Also, you should perform a “Save” before using “Update” to load a new software image, since the new
firmware could erase some of the settings.
5.5.7. Load
Loads a configuration file that has been previously saved or restores a backup.
Use “Browse” to navigate to the location where you saved the configuration file. Press Open, then click
“Send” to send the file to the BYTTON HSDPA equipment. A red progress bar will be displayed, and
above it you will see the blinking message “Updating settings, please wait”
