Toa SX-2100AO, Руководство по установке

Страница: 38 / 194

38
[Wall mount bracket unit (Accessory)]
23
24
[Bottom]
8
7
6
5
4
3
2
1
TERMINATION
CPU OFF
LEVEL METER
COMMUNICATION
UNIT ID
On Off
DIP SWITCH
20 21 22
20. DIP Switch [DIP SWITCH]
Used for setting the RM-200SF unit.
• Switches 1 – 3 [UNIT ID]
Set the RM-200SF's device number (ID number).
(See p. 66 .)
• Switch 4 [COMMUNICATION]
Sets the RM communication function.
(See p. 71 .)
• Switch 5 [LEVEL METER]
Changes a broadcast status indicator (12) into
an output signal level indicator. (See p. 68 .)
• Switch 6 [CPU OFF]
Sets whether the CPU OFF function (general
urgency all-call) is enabled or disabled.
(See p. 70 .)
• Switch 7
Not used. Normally set to OFF.
• Switch 8 [TERMINATION]
Sets the termination of the RM communication
line (Control communication lines between the
SX-2000 system and the RM-200SF). Normally
set to ON.
Note
By default, DIP switches 1 – 5 and 7 are set to
OFF, and DIP switches 6 and 8 to ON.
21. USB Terminal
Not used.
22. Extension Connector
Connect this connector to the extension connector
(23) of the Wall Mount Bracket Unit (accessory).
(See p. 80 .)
23. Extension Connector
Connect the cable extending from the RM-200SF
to this connector. (See p. 80 .)
24. Screw Terminal Block
• Audio Monitor Line [MONITOR IN]
Connect the audio monitor input line from the
SX-2000 system to the RM-200SF.
• RM Communication Line [DATA]
Connect the control communication line between
the SX-2000 system and the RM-200SF.
• Audio Output Line [AUDIO OUT]
Connect the audio signal output line from the
RM-200SF to the SX-2000 system.
• DC Power Input [DC IN 24 V]
Used to supply DC power from the SX-2000
system to the RM-200SF.
• Shield [SHIELD]
Used for the control line through which the
SX-2000 system confirms the RM-200SF's
connection.
Be sure to connect at least one of two terminals
to the SX-2000 system.
RM-200SF