Toa SX-2100AO, Руководство по установке

Страница: 28 / 194

28
COM
FAULT
KEYLOCK
EMERGENCY
OL
0
–10
–20
–30
–40
OL
0
–10
–20
–30
–40
FADER
LEVEL LEVEL
1 2 3 4 5 6 7 8
1 2
21
22 23 24 25 26 29 30 31 32 33 34 35 36 37
3 3
27 28
SX-2100AO
21. Text Display Area
Displays the menu screen information when the
corresponding function key is pressed.
22. COM Indicator [COM]
Flashes to indicate a communications error.
23. Fault Indicator [FAULT]
Flashes when a system failure, incorrect system
configuration*1 or communications error is
detected. This indicator continues to flash until
failure conditions return to normal.
*
1
When the system or module configuration
differs from the contents set by the SX-2000
Setting Software.
24. Output Level Meter Fader Indicator [FADER]
Lights when the output level meter indicates the
sound volume set using the SX-2000 Setting
Software or output volume control.
25. Output Level Meter Level Indicator [LEVEL]
Lights when the output level meter indicates the
level being output from the SX-2100AO.
26. Output Level Meter Scale
27. Output Indicator
The output channel to be monitored lights red.
In the case of speaker line initial setting, this
indicator lights when the channel is selected.
(For the speaker line initial setting, see p. 140 .)
28. Output ON/OFF Indicator
Indicates the unit's operating status when the
corresponding channel key is pressed.
The indicator state differs depending on the
function assigned to each channel key as follows.
*
2
The indicator state is "Unlit" when the output volume is muted.
In the case of speaker line initial setting, all
channel numbers 1 – 8 light up.
(For the speaker line initial setting, see p. 140 .)
29. Output Level Meter
Indicates the actual level, a set volume value, or
speaker line open/short status on each output
channel.
30. Emergency Indicator [EMERGENCY]
Lights when the SX-2000 system is in an
emergency condition.
31. Key Lock Indicator [KEY LOCK]
Lights when the output volume controls and
channel keys are locked. (See p. 152, "Key Lock
Settings and Cancellation" )
Notes
• A timer-activated light shutoff function can be set for the fluorescent display using the SX-2000 Setting
Software. (See the separate Setting Software Instructions, "Basic Settings.")
When the light shutoff function has been set, if the SX-2100AO is not operated for 5 minutes or more, the
fluorescent display's light goes off and the standby indicator (11) begins to flash. Pressing any keys other than
the function keys on the front panel resets the screen display.
• Normally, the fluorescent display's light goes off at the time of the power failure.
• While the SX-2000 system is in an emergency condition, the fluorescent display's light does not go off even
if the power fails.
[Fluorescent Display]
Function assigned to the channel key When ON When OFF
Output ON/OFF Lights*
2
Unlit
General-purpose pattern broadcast’s
activation and termination
Flashes Lights