TM RACING 125 EN 2022, Руководство по эксплуатации и обслуживанию

Страница: 85 / 130

4•85
44
2+ 2+
33
1- 1-
4 • MAINTENANCE
EN - 2-STROKE
BATTERY (EN - SMR)
Remove the seat to access the battery.
The battery does not require maintenance.
It is not necessary to check the electrolyte level or top up with water.
Simply keep the battery poles clean and, if necessary, lightly grease them
with acid-free grease.
To remove the battery, first disconnect the cable from the negative pole (-)
(1) then the cable from the positive pole (+) (2).
Disconnect the locking elastic band (3) and remove the battery.
To re-fit the battery, insert it with the terminals upwards and towards the
rear of the motorcycle (see figure).
Connect first the cable for the positive pole (+) (2) and then the cable for
the negative pole (-) (1).
DANGER
- KEEP FAULTY BATTERIES OUT OF THE REACH OF CHILDREN AND
DISPOSE OF THEM IN COMPLIANCE WITH THE REGULATIONS IN
FORCE.
- AVOID ANY CONTACT BETWEEN THE POLES.
NOTE:
For more information about the battery, see the introductory part of
this manual.
STORAGE
Do not store the battery in a room where temperature is higher than 50° or
lower than -10°. If you intend not to use the motorcycle for a period longer
than 15 days, it is advised to connect the battery to a charger or, alterna-
tively, remember to recharge it every 15 days to protect it from possible
damages. Always recharge the battery before it discharges completely in
order to prolong its service life. Damage caused by a prolonged lack of
recharge is irreversible and not covered by warranty.
Charge the battery ever three or four months.
In the event of prolonged storage (eight to ten months), charge to 100%,
then test the battery with a Voltmeter. For longer battery life, regular battery
maintenance must be carried out.
Make sure that batteries are kept out of the reach of children.
WARNING
- Do not use charge maintainers, battery tenders, fast chargers or other
similar devices.
- Use of these devices may damage the battery, cause dangerous
overheating, fires and explosions if they are not compatible.
- You must ALWAYS be present during battery charging.
- Do not charge the battery beyond the maximum voltage value indicated.
Check the external condition of the terminals and the plastic casing. Any
signs of damage or unusual wear can be checked during the service. If you
have any doubts about the condition of the battery, we recommend that
you seek the opinion of a professional fitter.
DANGER
- DO NOT REMOVE THE BATTERY COVER, AND DO NOT PIERCE OR CUT
THE OUTER PLASTIC CONTAINER: RISK OF SHORT CIRCUIT.