TM RACING 125 EN 2022, Руководство по эксплуатации и обслуживанию

Страница: 59 / 130

4•59
11
11
11
22
33
44
4 • MAINTENANCE
EN - 2-STROKE
BLEEDING THE TELESCOPIC FORK
After every 5 hours of competition use, use the bleeder screws or valves to
release any overpressure from inside the fork.
KAYABA USD FORK
The Kayaba fork has a screw (1).
- Before using the screw, lift the motorcycle onto a central stand so that
the front wheel is not touching the ground.
- Unscrew the screw (1) completely without removing it and bleed the
air.
- Tighten the screw (1) again.
- If the motorcycle is mainly used on the road, this operation only needs
to be performed during regular maintenance.
WARNING
Excessive pressure inside the fork may cause oil to leak from the fork. If your
fork leaks oil, try bleeding the air before replacing the sealing elements.
CLEANING TELESCOPIC FORK DUST SEAL
NOTE: You must contact a TM dealer to carry out this operation.
The dust seal (1) must prevent dust and dirt from entering the fork oil seal.
However, dirt may get behind the dust seal over time. If the dirt is not
removed, the oil seal ring, located behind it, may lose its seal.
Use a screwdriver to very carefully separate the dust seal (1) and the
scrapper (2) from the outer tube (3) and push it down.
- Carefully clean the dust seal (1), the scrapper (2), the outer tube (3) and
the inner tube (4) and liberally oil with silicone spray or with engine oil.
- Then re-fit the dust seal and the scrapper by manually pushing it into
the seat in the outer tube.
WARNING
Perform this operation on both of the fork dust seals.